First, replace the hydraulic oil
The replacement period of the hydraulic oil is one year (it can be shortened or extended according to your actual use), and clean the tank and filter while replacing the hydraulic oil. Hydraulic oil, please choose the standard number of 46 # regular big factory brand products.
Second, remove the dust
Remoof dust and foreign matter should be done daily (electrical dust) with special attention to sliding and turning parts. For Your Attention! Dust cleaning shall be performed after the machine is completely closed.
Third, fastening bolts
The fastening bolt is an important part of the maintenance link of the cutting machine. The loose bolt for a long time will break and cause more problems or accidents (it is recommended to do a inspection every three months is more appropriate).
Fourth, check the lubrication system
The sliding and rotating parts of the cutting machine need to be filled with lubricating oil, and good lubrication is necessary for the operation of the machine, so it is particularly necessary to check the automatic lubrication system regularly.
Fifth, check the table parallel degree
In practical use, it is impossible to make the knife die cut in the center of the cutting machine each time. A long time of eccentric cutting will lead to the parallel of the cutting machine, so as to accelerate the wear of the knife die and pad. Inspect the parallelism of the table regularly, you can grasp the parallel situation of the cutting machine at any time, so as to adjust the cutting position of the knife mold in use, correct the uneven position, so that the cutting machine is used longer, and play the best performance.
Attention to using the rocker arm cutting machine
Rocker arm cutting machine is a kind of cutting machine, which is very suitable for cutting small area of non-metallic materials in industry. So, what problems should we pay attention to when using the rocker arm cutting machine? Next, I will introduce the problems to use the rocker arm cutting machine.
1. When setting the cutter of the rocker arm cutter, you can first relax the set hand wheel, so that the set pole should contact the control switch of the cutting point, otherwise, when the set switch of the rocker arm cutter is turned to ON, the set action cannot be generated.
2, when you work, the cutter of the rocker arm cutting machine should be placed in the central position of the upper pressure plate, so as not to cause the unilateral wear of the rocker arm cutting machine, the unilateral wear of the rocker arm cutting machine will affect the service life of the rocker arm cutting machine.
3. When replacing the cutter of the new arm cutter, if the height is different, it is necessary to reset the cutter of the arm cutter according to the setting method.
4, when you use the rocker arm cutting machine for cutting action, the hand must first leave the rocker arm cutting machine cutting knife or cutting board, it is strictly prohibited to use your hand to help the knife mold to cut, otherwise it is very dangerous.
5, if the operator wants to temporarily leave the position of the rocker arm cutter, please be sure to turn off the motor switch, so as not to improper operation and damage the machine. We must also avoid overload use to avoid damage to the machine and thus reduce the service life.
Post time: Jun-22-2025